Aquatrac Instruments

Water Management Control Systems

    The Smart 1 Series has the precision of microprocessor control with the simplicity of an analog interface. Fully synthesized, AC coupled conductivity sensor drive for no-drift accuracy. Tight tower control with four field selectable inhibitor feed modes. Reliable boiler blowdown sampling with integeral flashing and fail-to-sample alarms.

   

 

The Smart AS Series (automated service) manages accounts on weekly and monthly service intervals. Record and display chemical and water usage, conductivity and pH compliance. Conductivity, pH/ORP biocide control with data logging and modem communications. Measure, monitor and control using water meters, chemical drum level sensors and flow switch inputs. Intelligent automation for cooling towers, boilers and wastewater.

   

 

The Smart FLEX Series allows a custom mixture of sensors, pumps, valves,switches and level sensors to optimize each sites' water treatment program. Mix boilers and cooling towers in one FLEX controller. Add serial, modem and network communications. Run a pre-configured FLEX out of the box or implement your own controls, timers and interlocks. Operate eight relays,record six water meters, measure fourteen sensors, monitor six switches....

    Aquatrac Liquid Level Sensors have a simple two wire sensor to measure liquid levels with fractional gallon resolution. Measure daily or weekly chemical usage. Dial-out and alarm on low drum level. Current loop powered directly from the controller. Extra power supplies are not required. Low noise electronics allows for long cabling distances to remote chemical tanks.

   

 

 Aquatrac Flow Meters
Low cost paddlewheels and turbines display gallons for the current and previous year at the controller. Meters high temperature and boiler feedwater. Eliminate the prohibitive cost of contact head water meters.

    Aquatrac Sensor Chambers
Simplify piping and locate your water treatment sensors at a single sampling point. Entries available for scaling and corrosion rate sensors.

 

    Aquatrac Boiler Hardware
Pre-assembled sampling piping simplifies boiler blowdown automation. Switch to the safety and low cost of 24VAC motorized boiler blowdown valves. Increase blowdown reliability by sensing failure-to-sample.